1Wireless Leaf & Soil Moisture/Temperature StationInstallation ManualFor Wireless Vantage Pro2™ and Vantage Pro2 Plus™The Wireless Leaf & Soil
102. Place a flat washer, a lock washer and a hex nut on each of the bolt ends. 3. Using an adjustable wrench or 7/16" wrench, tighten the nuts.4
11• To use one soil temperature sensor to provide compensation for multiple soil moisture sensors, install the temperature sensor in TEMP 1. • If the
12Finishing the Sensor Connections to the Station1. Secure sensor cables within the cable clamps located next to the grommets.2. Secure the cable clam
13Mounting the Sensor on a PipeTo mount the sensor on a pipe, stake, or pole with outside diameter between 1" and 1-1/4" (25 mm and 31 mm),
14will use a default temperature of 75° F (24° C) to compensate the soil moisture readings. Finishing the Sensor Connections to the Station1. Secure s
15Sprinkler Irrigation• Sprinkler irrigation usually provides a more uniform distribution of water to the ground surface, but there can be great diffe
16• Guidelines on proper depths for specific crops and conditions can be obtained from your local farm advisor. Irrometer also maintains an excellent
17• Carefully backfill the access hole with soil to eliminate any air pockets.5. You can solvent weld the 1/2” Class 315 PVC tubing to the sensor coll
18Troubleshooting the SensorsIf you are having problems with your station, please check all sensor cable connec-tions. Cable connections account for a
19Contacting Davis Technical SupportIf you have questions about your Leaf/Soil Station, or encounter problems installing or operating the station, ple
2ComponentsThe Leaf/Soil Station includes the following components and hardware:Optional SensorsThe following optional sensors are available for the L
Product Numbers: 6345, 6345OVDavis Instruments Part Number: 07395.267 Wireless Soil Moisture, Leaf Wetness, Temperature Station 2 Installation Manual
3Installation StepsFor ease of installation and use of your Leaf/Soil Station, please follow steps in the order presented. • Preparing the station, pa
4Installing the Battery1. Insert the 3-volt lithium battery into the battery holder, matching the “+” sign on the battery with the “+” sign next to th
5Soil Temperature Sensor ConnectionTemporarily connect a temperature probe to the TEMP 1 terminal block connector.1. Use a pen or small screwdriver to
6. Setting Console/Receiver(s) to Same ID1. Put your console into Setup Mode — press and hold DONE and press the down arrow (-). • The console display
7Testing Station Communications1. If you are using a Soil Moisture sensor to test the station, press TEMP until you see “SOIL MOIST” displayed on the
8If the LED flashes repeatedly but your console isn’t picking up a signal anywhere in the room, it could be related to one of the following causes: •
9Testing Transmission from Proposed LocationIt is very important to test reception from the proposed location before permanently mounting the Leaf/Soi
Kommentare zu diesen Handbüchern