DAVIS Wireless Repeater 7625 Installationshandbuch PDF herunterladen (Seite 11)

Mounting the Anemometer Transmitter Page 11

3. Swivel the anemometer until the arm is pointing north.

4. Using an adjustable wrench or 7/16" wrench, tighten the nuts.

If the anemometer arm is not pointing north, follow the instructions in

Appendix C in your ISS manual.

Mounting Anemometer on a Vertical Surface

1. With a 3/16" (5 mm) drill bit, drill two holes approximately 2-1/8" (54 mm) apart. Use a

carpenter’s level to ensure the holes will be level.

2. Insert the 1/4" x 3" lag screws through the ﬂat washers and the holes in the mounting

base into the post.

MOUNTING ANEMOMETER ON A VERTICAL SURFACE

3. Using an adjustable wrench or 7/16" wrench, tighten the lag screws.

If the anemometer arm is not pointing north, follow the instructions in

Appendix C in your ISS manual.

1/4" Flat Washers

1/4" x 3" Lag Screws

40' of Anemometer Cable

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Keine Kommentare

DAVIS Wireless Repeater 7625 Installationshandbuch Seite 11