Davis Vantage Vue Integrated Sensor Suite Manual Bedienungsanleitung

3465 Diablo Ave., Hayward, CA 94545 USA510.732.9229 • www.davisnet.comIntegrated Sensor Suite Installation ManualModel #6357®

ISS Installation Guidelines8• Ideally, mount the ISS so that it is between 5’ (1.5 m) and 7’ (2.1 m) above the ground in the middle of a gently slopin

ISS Installation Guidelines9Recommended Accessories for Pole Mounting• Use the Mounting Tripod (#7716) for easiest mounting.• Use the Mounting Pole Ki

ISS Installation Guidelines107. If you are in the Northern Hemisphere, rotate the ISS on the pole so that the solar panel is facing south; if you are

11Maintenance and TroubleshootingMaintenanceCleaning the Radiation ShieldThe outer surface of the radiation shield should be cleaned when there is exc

Troubleshooting121. Unscrew the thumbscrew securing the tipping spoon assembly to the ISS base. Slide the assembly down and away from the base. 2. Use

Troubleshooting13Problems Using Two Transmitting StationsA single Vantage Vue console can receive signals from one ISS, either a Vantage Vue or a Vant

14Appendix A: SpecificationsSee complete specifications for your Vantage Vue station on our website: www.davisnet.comIntegrated Sensor Suite (ISS) Spe

Integrated Sensor Suite Installation Manual.Rev. E, 4/30/12Document Part Number: 07395.262For Vantage Vue Weather Stations and SystemsVantage Vue®, Va

1IntroductionThe Vantage Vue® wireless Integrated Sensor Suite (ISS) collects outside weather data and sends the data wirelessly to a Vantage Vue cons

2HardwareHardware included with the Vantage Vue ISS:Note: If any of the hardware components are missing or not included, contact Customer Service tol

3Attach the Wind Cups to the AnemometerThe Vantage Vue anemometer measures wind speed. The wind cups are mounted on the anemometer shaft on the top of

4Install the Rain Collector Tipping Spoon Assembly 1. Locate the tipping spoon assembly slot on the underside of the ISS Base. 2. Insert the wider end

5When you release the pushbutton, the LED will blink once (indicating transmitter ID 1), then begin to flash every 2.5 seconds to show transmission of

6mometer Transmitter Kit with ID 1.To set a new transmitter ID:1. Push and hold the transmitter ID pushbutton until the LED begins flashing quickly. T

7Installing the ISSChoosing a Location for the ISS The ISS assembly includes the rain collector, wind vane, anemometer, temperature and humidity senso