DAVIS WeatherLink Anleitung zur Fehlerbehebung PDF herunterladen (Seite 8)

REMOTE CONNECTION FOR VANTAGE PRO

Hardware Requirements

2. At the station console site, put the external modem in a location where it can

connect to both the logger and a phone jack and plug it into the phone jack.

IMPORTANT: DO NOT TURN THE MODEM ON AT THIS TIME.

The cable connecting the data logger to the modem is 8’ (2.4 m) long. If you

need to mount the station console more than 8’ from the modem, use a 40’ (12

m) standard 4-conductor extension cable. Do not attempt to use more than 40’

of extension cable, or the data logger may have difficulty communicating with

the modem.

3. Plug the external modem into the phone jack.

4. Place the console in setup mode.

Press and hold the DONE key, then press the DOWN arrow key. Entering

Setup Mode ensures the station is not writing any data to memory and saves

all current highs, lows, and daily totals.

5. Remove the battery cover from the console back and remove all power by

removing the batteries and AC-power adapter, if present.

Failure to remove power to the console before installing the data logger may

cause damage to the data logger or console.

6. Carefully insert the data logger into the large receptacle jack marked

EXPANSION inside the battery compartment

Guide the data logger cable through the square slot below the data logger

receptacle.

CAUTION: Make sure that whenever you connect or disconnect the data logger from

the console that the console is NOT powered up. Plugging or unplugging the

data logger while power is applied can damage or lock up the data logger.

7. Connect the blue Telephone Modem Adapter to the external modem.

Do not use a DB25 (not included) adapter and a gender changer to attach the

logger to a modem because it will not work. Do not use a black Davis tele-

phone modem adapter, either, as it will not work with the Vantage Pro.

8. Insert the cable plug at the end of the cable into the Telephone Modem

Adapter.

9. Restore power to the weather station by reinstalling the batteries and reat-

taching the power adapter, if present.

The weather station should beep three times; each beep should occur within

about one second of the others.

10. Replace the battery cover, ensuring that the data logger cable exits through

the square slot.

11. Turn the modem ON.

Turning the modem on at this point allows it to receive the modem initializa-

tion string from the console.

12. Set the baud rate on the Vantage Pro console.

Enter Setup on the console by pressing and holding the DONE key, then press-

ing the DOWN arrow key. Use the BAR and DONE keys to scroll through the

setup screens until you reach the BAUD RATE setup screen.

CAUTION:The Baud Rate setup screen will only appear if you have installed the data

logger.

WL Windows GSG content D009.fm Page 6 Friday, September 12, 2003 12:29 PM

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Kommentare zu diesen Handbüchern

Keine Kommentare

DAVIS WeatherLink Anleitung zur Fehlerbehebung Seite 8

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Wetterstationen DAVIS WeatherLink