Product number 7714RadiationShieldUSERMANUALDavis Instruments, 3465 Diablo Avenue, Hayward, CA 94545-2778 U.S.A. • 510-732-9229 • www.davisnet.comR
8If you are attaching the radiation shield to the top of a post:The instructions for assembling the radiation shield differ slightly if you are mounti
92. Place a #8 flat washer over the end of each of the #8 x 2 3/4” pan head screws.As long as the extra length of screw end protruding from the bottom
10Assemble the Radiation ShieldTo assemble the radiation shield plates you will need the plates and studs assembly, as well as the rest of the plates,
11Mount the Radiation ShieldFollow the instructions below to mount the radiation shield. There are separate sections for each of the mounting options.
12Mounting on a Pipe:In order to mount the radiation shield onto a metal pip with outside diameter between 1” and 1 1/4” (25 mm and 31 mm), you will n
134. Secure the mounting bracket to the pipe using a 1/4” flat washer and a 1/4” hex nut on each end of the 1/2” U-bolts.Tighten until the mounting br
Radiation ShieldProduct Number 7714Document Number: 07395.093 Rev. D, April 19, 2013© Davis Instruments Corp. 2013. All rights reserved. Information
1 Radiation Shield (7714)The radiation shield allows the temperature sensor to accurately measure air temperature without the effects of direct radiat
2• Four 1/4” x 1 1/2” (38 mm long) lag screwsTo attach radiation shield to a post or wall.• Three #8-32 x 1” (25 mm long) screwsTo attach radiation sh
3Attach the SensorUse the radiation shield to house an external temperature sensor (Temperature Probes with RJ Connector, p/n 7817 or 6477; or Stainle
45. Once secured, adjust the position of the sensor so the probe and approximately 1/4” (6 mm) of cable protrude from the clip mounts.6. Place the cab
5Attach the Support Plate to the Cover PlateTo attach the support plate, you will need the cover plate, the support plate, three #8 x 2 3/4” pan head
6Assemble the Plates and StudsTo assemble the plates and studs, you will need the cover plate assembly as well as the flat plate and close plate with
7If you are attaching the radiation shield to the side of a post or to a wall or a pipe:1. Slide the three open plates and the two remaining closed pl
Kommentare zu diesen Handbüchern