Davis Anemometer Transmitter Kit Bedienungsanleitung PDF herunterladen (Seite 4)

Setting the Transmitter ID

Each wireless transmitting station must be set to one of eight transmitter IDs. DIP

switches #1, 2 and 3 on the SIM allow you to control the ID — the “channel” the station

will transmit on. (DIP switch #4 is used for transmission testing, not for transmitter ID.)

Note: The transmitter and your console communicate with each other only when both are set to the

same ID.

The factory default transmitter ID is ‘1’. Looking at the table below, you can see that

means all three DIP switches are in the OFF position when each transmitting station

leaves the factory, whether it is an ISS, an anemometer transmitter, or another kind of

station.

The ISS is included with every Wireless Vantage Pro,

and the console/receiver is factory

set to find the ISS on ‘1’. Since it is likely that your ISS is already set to ID ‘1’, you

will need to set the ID of your anemometer transmitter to a different ID number.

Use a ballpoint pen or paper clip to toggle DIP switches #1, 2, and 3. The settings for

transmitter IDs 1 – 8 are shown in the table below:

ID CODE SWITCH 1 SWITCH 2 SWITCH 3

#1 (default) off off off

#2 off off ON

#3 off ON off

#4 off ON ON

#5 ON off off

#6 ON off ON

#7 ON ON off

#8 ON ON ON

Use this table to ensure that each wireless transmitting station in your system is

broadcasting on its own transmitter ID.

1234

Battery Holder

DIP Switches

DIP SWITCHES IN TOP-RIGHT CORNER OF SIM (ILLUSTRATION HAS BEEN ENLARGED FOR CLARITY)

1 2 3 4 5 6 7 8 9 10 11 12

Keine Kommentare

Davis Anemometer Transmitter Kit Bedienungsanleitung Seite 4