Davis Wireless Temperature Station Bedienungsanleitung PDF herunterladen (Seite 5)

Setting the Transmitter ID Page 5

Setting Console/Receiver(s) to Same ID

1. Put your console into Setup Mode — press and hold the DONE key and press the

DOWN arrow key.

The console will show you Screen 1: Transmitters. You should see the words:

“RECEIVING FROM...” and “STATION NO.” followed by the transmitter

IDs that your console detects. One of these should be the ID number you just

set on the temperature station transmitter. If you don’t see it, make sure the

console is within 10' of the transmitter, and verify that you set the DIP

switches correctly. If you still don’t see it, go to “TEST mode” on the next

page.

2. Press the DONE key to move on to Screen 2: Selecting Transmitters.

Setup Mode – Screen 2 is where you will set the console to recognize signals

on that ID as coming from a temperature station.

3. Press the LEFT or RIGHT arrow key, or the STATION key, to scroll through transmitter

IDs.

When you see the ID you chose for the temperature station, use the UP or

DOWN arrow keys to activate reception of that ID code. Make sure the

screen shows “ON”.

4. Press the GRAPH key to change the type of station assigned to that transmitter ID.

Press the GRAPH key until the word “TEMP” appears.

5. To exit Setup Mode, press and hold the DONE key.

(See the

Vantage Pro User’s Manual & Setup Guide

: “Setup Mode – Screen 2:

Selecting Transmitters.”)

Viewing Current Temperature

Press the TEMP key until you see an ‘outside’ temperature displayed on the

console screen, with the correct Station No. displayed above or below it. This

conﬁrms communication between your temperature station and the console —

go on to “Choosing a Location for the Wireless Temperature Station” on page 6.

If You Do Not See Current Values from the Correct Station No.

First, verify that the console/receiver is powered and is not in Setup Mode (exit

Setup Mode by pressing DONE key and holding it for a moment). Then, on the

temperature station, check that the battery is properly installed. Walk around

the room with the console, standing for a few moments in various locations to

see if you are picking up signals.

If you don’t see readings no matter where you stand with the console, put the

transmitter in TEST mode.

Wireless Temp Page 5 Thursday, December 7, 2000 2:09 PM

1 2 3 4 5 6 7 8 9 10 11 12

Keine Kommentare

Davis Wireless Temperature Station Bedienungsanleitung Seite 5