DAVIS Electronic Rain Counter Betriebsanweisung Seite 24

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 90
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 23
C3 User Guide
22
Cable routing option 1: Bottom entry
Remove the Solar Enclosure from packaging and assemble to mount via
tabs, the enclosure need not be held in place once on the mount (Figure
9, follow sequence 1-2)
Extend the solar panel outward slightly and open the enclosure door
Remove the hardware pack
Place the enclosure on the mount (Figure 9) and secure using the small
thumb bolt and washer supplied in the hardware pack (Figure 4-6)
Extend solar panel out to the desired angle (see appendix A3), lock in
place by tightening large thumb screw (Figure 4-1)
Install the large M32 cable gland supplied in the hardware pack into the
bottom entry hole, noting that the seal should be on the outer face of the
enclosure (Figure 4-8)
Cable routing option 2: Rear entry
Select a drill with a diameter to suit the cable being used
Drill one or both cable entry holes through mount/pole/wall using pilot
marks in mount as a guide (Figure 7-3)
Feed equipment cables up pole and through holes made above
After pole has been secured, remove solar enclosure from packaging
extend solar panel outward slightly, open door and remove hardware pack
Drill one or both cable entry holes in rear of solar enclosure using pilots
marks and 16 mm drill or hole-saw (Figure 8-2)
*OTUBMMUIFTVQQMJFEQJFSDFUISPVHIDBCMFHMBOETçBUTJEFGBDJOHPVUXBSE
(Figure 8-3)
Feed cable through cable glands as the enclosure is being assembled to
the mount
Place the enclosure on the mount (Figure 9) and secure using the small
thumb bolt and washer supplied in the hardware pack (Figure 4-6)
Extend solar panel out to the desired angle (see appendix A3), lock in
place by tightening large thumb screw (Figure 4-1)
Install the M32 plug supplied in the hardware pack into the bottom entry
hole, noting that the seal should be on the outer face of the enclosure
Seitenansicht 23
1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 89 90

Kommentare zu diesen Handbüchern

Keine Kommentare